Stepper Gear Motor CNC Mill Lathe Router 56 NEMA23 AC DC 2Purpose DIY

  
Imported good-quality motor steel sheet, bearing made of German craftsmanship, possess low self-inductance and good responsiveness 2. Can be directly connected to the load and run at low speed without gear reduction when it is close to the locked-rotor state, so a high torsion to inertia ratio can be generated on the load shaft, and the system error caused by the use of reduction gears can be eliminated 3.

The inner rotor adopts German technology, and the is coated with imported rotor glue to prevent burrs on the after the carbon steel is oxidized and ground, causing the motor noise to increase 4. The front and rear covers are perfectly connected, the body is black electrophoresis, high-end and generous, and the body size is standard 5. Quick start and stop, frequent CW and CCW, accurate control, the number of pulses determines the position of the motor.

Item Type: Stepper Gear Motor Material: Carbon steel, silicon steel, copper Step Angle: 1.8° Step Angle Accuracy: ±5% Resistance Accuracy: ±10% 20? Inductance Accuracy: ±20% (1KHz) Temperature Rise: 80? Maximum Insulation Resistance: 100MO Min, 500VDC Withstand Voltage: 500VAC/Min Radial Maximum Load: 75N Axial Maximum Load: 15N Radial Clearance: 0.02 Maximum Axial Clearance: 0.08 Maximum Ambient Temperature: -20? 1.2 g / 0.04 oz. 1.5 g / 0.05 oz. 1 x Stepper Gear Motor. When connecting the motor to the driver, do not connect the wrong phase. Correctly select the reducer model and reduction ratio according to the accuracy required by the machine. Due to the different driving conditions, the motor may have obvious heat generation.

The temperature of the motor is not allowed to exceed 85? When installing the motor, be sure to use the front end cover of the motor for positioning, and pay attention to the tolerance matching to ensure the concentricity of the motor shaft and the load. We will reply your message within 48 hours. If you do not receive our reply within 48 hours, pls.

Post a message again because sometimes our message system may block some emails. If you are satisfied with our service, pls. Our aim is to provide Level Customer Service, your recognition will encourage us greatly and serve you better.

We strive to keep all our customers satisfy. We will do our up most to exceed your expectations in customer service, communication and dispatching of your orders.