Drive Specifications& Feature Type:DSP Closed loop vector control stepper drive maximum peak current:5A Impulse response frequency:200Khz Micro-stepping driver:20051200ppr Voltage:DC24-60V Protective function:Over voltage, over current, tracking error, overproof Signal input:Support PUL/DIR and CW/CCW modes (difference) Compatible 524V signal (Don't need a resistor) Continuous overload:Output an alarm signal Type of cooling:Air-cooling Environment:Keep away from dust, oil, corrosive gas, high humidity and high vibration Application temperature:050 degree centigrade. DSP Closed Loop Stepper Drive Motor 2.3NM Nema23 +200W Power Supply +3M Cables. (with 118 inch Power Cable). DSP Closed loop vector control stepper drive.
Over voltage, over current, tracking error, overproof. Support PUL/DIR and CW/CCW modes (difference). Compatible 524V signal (Don't need a resistor).Keep away from dust, oil, corrosive gas, high humidity and high vibration. 0.85 ohm +/-10%At 20. When the motor is continuously overloaded, the driver will output an. In time, which has the same reliability as the AC servo system. It is suitable for all kinds of small and medium-sized automation equipment and instruments, such as: engraving machine, wire stripping machine, cutting machine, laser machine, plotter, CNC machine tool, automatic assembly equipment, electronic processing equipment, textile and garment equipment. It is especially effective in applications where users expect low noise and high speed.
Power LED does not light after power 1. Check the connection of the power line. The voltage maybe too low 2. Check the connection of the motor with power, 2. Input voltage of the driver maybe too high or too low 3.The motor do not turn when the pulse input 1. Whether the pulse input of the driver is connected stably 2. Whether the input way in the system configuration of the driver is pulse input 3. Whether the motor can be released 4. Red light alarm after running a small angle 1. Whether the phase wire of the motor is correctly connected. If it is not correct, please refer to the motor phase and the corresponding phase sequence of the driver. In the driver configuration parameters, whether the number of motor encoder lines is consistent with the connected motor parameters. If they are different, you need to reset them. Whether the pulse input speed is greater than the rated speed of the motor. Please see the details above.
We are a leading provider for industrial automation control, CNC machine and electrical equipment. Each product, in which FastToBuy sales online, is subject to a 100% quality control. We will reply you ASAP. Feedback, so that we can satisfactorily solve your concerns. This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Electric Motors\Stepper Motors".
The seller is "fasttobuy2012" and is located in this country: CN. This item can be shipped worldwide.