4pcs Nema17 Stepper Motor 42 motor CNC shield v3 Engraving Machine A4988 Driver CNC Shield Board: 1, Latest CNC Shield Version 3.0 for Ardu ino. 2, GRBL 0.9 compatible. (Open source firmware that runs on an U NO for Ardu ino that turns G-code commands into stepper signals) 3, PWM Spindle and direction pins 4,4-Axis support (X, Y, Z, A-Can duplicate X, Y, Z or do a full 4th axis with custom firmware using pins D12 and D13) 5,2 x End stops for each axis (6 in total) 6, Coolant enable 7, Uses removable A4988 or DRV8825 compatible stepper drivers 8, Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping) 9, Compact design. 10, Stepper Motors can be connected with 4 pin molex connectors or soldered in place.11, Runs on 12-36V for DC. At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board. 12, Please note that this is an unassembled kit and Basic soldering skills are needed. A4988 Stepper Motor Driver: 1, A4988 Stepper Motor Driver Board is a breakout board for Allegro's A4988 DMOS Micro stepping Driver with Translator and Overcurrent for Protection; please read the A4988 datasheet carefully before using this product.
This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Electric Motors\Stepper Motors". The seller is "yiyi59_39" and is located in this country: CN. This item can be shipped worldwide.