3.6NM Nema23 428Oz-in Hybrid Servo Stepper Motor Drive DSP System Closed Loop

3.6NM Nema23 428Oz-in Hybrid Servo Stepper Motor Drive DSP System Closed Loop. 3.6NM Nema23 Hybrid Servo Stepper Motor 428Oz-in Drive DSP System Closed Loop CNC. Here is the link for. When the motor is continuously overloaded, the driver will output an.

In time, which has the same reliability as the AC servo system. DSP Closed loop vector control stepper drive. Over voltage, over current, tracking error, overproof. Support PUL/DIR and CW/CCW modes (difference). Compatible 524V signal (Don't need a resistor). Keep away from dust, oil, corrosive gas, high humidity and high vibration. 1.15 ohm +/-10%At 20. It is suitable for all kinds of small and medium-sized automation equipment and instruments, such as: engraving machine, wire stripping machine, cutting machine, laser machine, plotter, CNC machine tool, automatic assembly equipment, electronic processing equipment, textile and garment equipment. It is especially effective in applications where users expect low noise and high speed. (with 118 inch Power Cable).

Power LED does not light after power 1. Check the connection of the power line. The voltage maybe too low 2. Check the connection of the motor with power, 2.

Input voltage of the driver maybe too high or too low 3. The motor do not turn when the pulse input 1. Whether the pulse input of the driver is connected stably 2. Whether the input way in the system configuration of the driver is pulse input 3. Whether the motor can be released 4.

Red light alarm after running a small angle 1. Whether the phase wire of the motor is correctly connected. If it is not correct, please refer to the motor phase and the corresponding phase sequence of the driver. In the driver configuration parameters, whether the number of motor encoder lines is consistent with the connected motor parameters.

If they are different, you need to reset them. Whether the pulse input speed is greater than the rated speed of the motor. We will reply your message within 48 hours. If you do not receive our reply within 48 hours, pls post a message again because sometimes our message system may block some emails. Instead of leaving negative/neutral feedback or opening a dispute.

If you are satisfied with our service, pls. Our aim is to provide Top Level Customer Service, your recognition will encourage us greatly and serve you better.

We strive to keep all our customers satisfy. Like LCD screen, industrial burner accessories, printer accessories, instrument accessories, and other fields solutions, we supply Sumsung, LG, AUO, Xinje, Riello, Honeywell, Dungs, Mitsubishi, Siemens, Heidelberg machine parts and The international famous brand accessories etc. This item is in the category "Business, Office & Industrial\Industrial Automation & Motion Controls\Electric Motors\Stepper Motors".cnc" and is located in this country: CN.

This item can be shipped worldwide.

Brand: ToAuto
Model: HBS57+57HBS36
Country/Region of Manufacture: China
Voltage: DC24-60V
Holding Torque: 3.6NM
Signal input: Support PUL/DIR and CW/CCW modes
Full Step Angle: 1.8° (200 Steps)
Current Type: DC
Shaft Diameter: 8mm
Nominal Rated Input Voltage: 24 V, 48 V
EAN: DoesNotApply