HSS86 is a two-phase hybrid stepper motor servo driver, adopting new 32-bit control technology and vector control technology that can prevent loss of movement synchronization and ensures accuracy. High-speed torque attenuation is far lower than the traditional open-loop driver, which can greatly increase high - speed performance and torque of stepper motor.
Load-based current control technology can effectively reduce temperature rise of motor and prolong motor service life. Built-in position and alarm output signal is convenient for PC monitoring and controlling. Position out-of-tolerance alarm function ensures machining equipment safe operation. The driver is a great replacement for traditional open loop stepping driver and can replace part of traditional AC servo system. The driver uses advanced 32-bit special motor control chip and vector closed-loop control technology.Stepping closed-loop circuit system, no loss of movement synchronization. Improve motor output torque and speed. Current is adjusted depending on the load, reducing motor temperature rise.
Fit for all kinds of machinery load conditions (including low rigidity belt wheel and pulley) without adjusting the gain parameters. Motor runs smoothly, vibrates mildly, and improves acceleration and deceleration dynamic performance. Zero speed static ability of no vibration after completion of positioning. Maximum 51200 steps/rotation, 16 kinds of optional segment.It supports over current protection, over voltage protection, position out-of-tolerance protection. Peak Output Current: 5.0A (current changes along with load). Encoder B phase input +. Encoder A phase input +. Encoder power supply +(+5V).
Encoder power supply GND(0V). (Incorrect encoder wiring will cause driver or encoder damage). If control signal level is 5V, no need to connect resistor to signal input. If control signal level is 12V, a 1K resistor need to be connected to signal input in series. If control signal level is 24V, a 2K resistor need to be connected to signal input in series.OC door output, close indication location is complete, open indication location is incomplete. OC door output, close indication has alarm signal, open indication has no alarm signal. Green light is on when power on. Red light flashing once within 3 seconds indicates over-current or interphase short circuit; red light flashing twice within 3 seconds indicates over-voltage; red light flashing three times within 3 seconds indicates position out-of-tolerance protection. Instead of leaving negative/neutral feedback or opening a dispute.
Our listing price includes the value of goods, packaging cost, and export. Please check with your country's. We will reply your message within 48 hours. If you do not receive our reply within 48 hours, pls.
Post a message again because sometimes our message system may block some emails. If you are satisfied with our service, pls. Our aim is to provide Level Customer Service, your recognition will encourage us greatly and serve you better.
We strive to keep all our customers satisfy. We will do our up most to exceed your expectations in customer service, communication and dispatching of your orders. This item is in the category "Industrial\Industrial Automation & Motion Controls\Electric Motors\Stepper Motors". The seller is "industry_shop" and is located in this country: CN. This item can be shipped worldwide.