12Nm Closed Loop Stepper Motor Driver Nema34 +3Axis Controller & Handwheel&Power

  

Package Included : 3 x Drive HBS860H 3 x Motor 86HBS120 1 x Ring Transformer 900VA 60VAC 1 x Offline Controller+1PCS Handwheel CSV3.1-3 3 x Encoder Cable 3-meter 3 x Power Cable 3-meter Features : HBS860H uses advanced motor control DSP chip and vector loop control technology. Completely offline control, no need other computer to control for engraving machine. High control precision and reliable, low noise and little vibration.

The pulse width can be adjusted. With English panel display, with handwheel, easy update your soft via USB flash drive. 12Nm Closed Loop Stepper Motor Driver Nema34 +3Axis Controller & Handwheel&Power. 1 x Ring Transformer 900VA 60VAC. 1 x Offline Controller+1PCS Handwheel CSV3.1-3. 3 x Encoder Cable 3-meter.

3 x Power Cable 3-meter. HBS860H uses advanced motor control DSP chip and vector loop control technology. Here is the link for CNC Controller. Ordinary digital 3-circuit optocoupler coupling isolation. 0-10V spindle control port with analog quantity(can be modified as PWM output).

4.3 inches TFT 480272. USB flash disk to read the G code. Support the general MPG in the market. Support the panel key with single-axis manual operation, manual step and CONT operation. Support the operation of quickly specify the running position.

Support the multi coordinate systems (with automatically saving function in case of power cut). Support the function of saving data automatically after power down (press the start to automatically save the data in the operation, automatically save the data after power down). The control period of each position is only 4 second. The ARM can finish the part of human-computer interface and code analysis.

The FPGA can finish the part of underlying algorithm and control pulse generate. The common off-line operation can be finished only by 17 keys. Supports the FANUC with high universality to be compatible with G code set. Port of the controller is extensible(8 Input/12 relay output). Less than or equal to 80mA.

8 input and 12 output extension board(M code). DSP Closed loop stepper drive. Over voltage, over current, tracking error, overproof. Support PUL/DIR and CW/CCW modes.

Compatible 524V signal (Don't need a resistor). 24VDC power input, minimum Current is 0.5A. USB flash disk support for G code file input, no size limited of the G-code file. General MPG in the market. Jog function for each axis (continuous, step, defined distance).

Support the origin and Limit share the same Input ports. The controller only support NPN type limited switch. If you need any CNC parts or repairs, welcome to contact me, we will try our best to help you.